Here are a few simple steps to ensure that your water cooler stays clean and your Diamond Springs water tastes its best.
Supplies you will need:
- Clean rubber gloves
- Paper towels
- Lint-free towel
- Plastic scrub brush (a long handle will make cleaning easier)
- Teaspoon measuring spoon
- Calibrated container (2-gallon bucket)
- Unscented household liquid bleach
- Clean 1-gallon container filled with bottled water
Remember to never use soap or detergents, steel wool, or any other abrasives on your reservoir(s).
First unplug your power cord. Remove the bottle from the cooler. If there is still water in the bottle, make sure that you cap or cover the bottle for re-use.
From the COLD faucet drain all the water from the cooler into a bucket and discard the water. After, remove the cooler top. If the cooler is equipped with a no-spill device, it may need to be removed first. Look in the reservoir to see if there is a removable baffle. If so, remove the baffle.
If there is remaining water in the cold-water chamber, drain it out. If the reservoir has an ice ring in it, add hot water to melt the ring and completely drain the reservoir. DO NOT spill water outside the reservoir into the interior of the cooler.
Prepare the cleaning solution in the calibrated container. Add 1 teaspoon of unscented household liquid bleach to each gallon of water.
Wearing clean rubber gloves immerse the lint-free towel and/or scrub brush in the cleaning solution. Squeeze all excess cleaning solution from the towel and aggressively clean all surfaces of the reservoir interior. DO NOT pour the cleaning solution directly into the reservoir.
To rinse the reservoir, carefully fill the reservoir with bottled water from the 1-gallon container until it reaches ½ inch from the top of the reservoir. Next, drain the “rinse” water from the reservoir through the COLD faucet.
Use the same cleaning solution brush and/or cloth to clean the baffle, the cooler top, removable drip tray, and faucets. If your cooler is equipped with a no-spill device, it should be cleaned with the same cleaning solution. Use the clean 1-gallon container filled with bottled water to thoroughly rinse these parts.
Wearing clean rubber gloves, re-install all parts: baffle, cooler top, faucets if removed, and no-spill device (if equipped). Place a bottle back on the cooler and drain 2 cups of water from each faucet, or until there is no evidence of chlorine taste and/or odder.
Dry any excess water that has spilled on the cooler and/or the floor. Then, plug the cooler back into the electrical outlet. Allow at least 45-minutes for the water to reach the appropriate temperature.
If you have followed these steps, you now have a clean cooler and have taken an active role in preserving the quality of the equipment you use to dispense your bottled water.